Kustom KG100HFX - Manual (Page 6)

kustom.com
Speaker Output: This is a 1/4-inch speaker jack that is used to connect the KG100HFX to a speaker cabinet. Rating
is 4-ohms minimum. For full power, use a 4-ohm load. (The Kustom KG412 speaker cabinet is the ideal match for the
KG100HFX both in terms of impedance and tonality.)
Footswitch: This ¼-inch jack is used to connect an optional footswitch to the amplifier. The Kustom model KACFS-
100 may be purchased separately. This single-button footswitch can be used to select between the Lead and Rhythm
channels while playing.
Effects Loop Send: Use this 2-conductor, ¼-inch jack to connect to the input of an external effects processor or
equalizer. This jack can also be used as a Preamp Out.
Effects Loop Return: Use this 2-conductor, ¼-inch jack to connect to the output of an external effects processor or
equalizer. This jack can also be used as a Power Amp In. (Note: This jack separates the preamp from the power amp. If
using an external effect, the effect will be in series between the Effects Loop Send and Effects Loop Return. The amount
of “dry” signal will be controlled by the external effect.)
1. AC Power Cord Receptacle: AC power cord can be removed for easy
storage and replacement if damaged. Insert the AC cord (provided) firmly into
the AC receptacle.
NOTE: Replace the AC power cord if protective jacket is
damaged or ground pin is damaged or removed.
2. Fuse: The fuse is located in a fuse tray just below the receptacle. Replace
only with the same type and size. For your convenience, a spare fuse is located
inside the fuse tray toward the front. To replace fuse, remove AC power cord.
Remove fuse tray by pulling the tab located above the fuse symbol away from
the receptacle.
KG100HFX Back Panel
KG100HFX AC Mains