Kathrein MobiSet 3 CAP 310 - Manual (Page 20)

20
Set up electrical connections. Connect UFD 170/UFD 540 receiver.
Connect connecting/control unit to battery.
Installation and connection
The antenna must always be lowered into horizontal position
(park position) while driving!
Maximum driving speed of the vehicle: 130 km/h
Installation of UFD 170
The turntable is actuated exclusively by the UFD 170 combi satellite
receiver.
The cable lengths must be taken into account when choosing the
installation location.
The UFD 170 is equipped with a power saving circuit and a separate
infrared transmitter, which means that the unit does not need to be
placed where it is visible. You can therefore fi t the UFD 170 out of sight
in any location, e.g. on cupboard walls, side walls or the base of storage
compartments.
Note: When choosing the installation location, bear in mind that the on/off
switch, the fuse for subsequent monitoring and the slots for inserting
common interface modules should always be accessible.
In addition, the following points should be taken into account:
• The wall thickness at the installation location must be at least 12 mm,
as otherwise the screws will emerge on the other side or damage
the surface
• The receiver must be placed in such a way as to allow suffi cient
air circulation behind, above and next to the unit. Installation on
carpet-covered walls is therefore unsuitable
• Ensure that the cupboard or storage compartment in which the unit
is housed is adequately ventilated, to prevent a build up of heat
• No cables etc. placed behind or in the wall should be damaged when
tightening the screws
• The receiver is designed exclusively for installation in dry, interior
locations. The installation location must be protected against
moisture
• The connecting cables must be strain relieved