Kawai CN4 - Manual (Page 14)

10 KAWAI DIGITAL PIANO CN4
First press the desired SOUND SELECT button to select the upper
sound. Then, while holding down the SPLIT button, press the
desired SOUND SELECT button to select the lower sound. The
LED Indicator for the upper sound will be turned on and the LED for the
lower sound will start flashing.
The LCD Display shows you which sounds are
selected for the upper and lower sections.
CHANGING THE SPLIT POINT
The default split point is set between B2 and C3. This point can be moved
to anywhere on the keyboard.
Press the desired key while holding down the SPLIT button.
The LCD Display shows you which key you pressed
The key you pressed becomes the lowermost note for the upper section.
2.4 B
ALANCE
S
LIDER
You can adjust the volume balance between the two sounds in Dual or
Split mode. Use the BALANCE slider to adjust the balance. Move
the slider to the right to increase the volume of the sound shown on the
top line of the display and decrease the volume of the sound shown on
the bottom line of the display. The balance changes in the opposite way
when the slider is moved to the left.
2.5 E
FFECTS
/R
EVERB
You might have noticed that when you select some of the preset sounds,
the LED indicator for the EFFECTS or the REVERB is turned on. The
reason for this is some of the preset sounds are set up with an effect on as
their initial setting.
Adding an effect to the sound enhances tonal quality and improves
acoustical realism. The CN piano is provided with two separate groups
of effects. The first is reverb and the second contains chorus, flanger,
delay, tremolo and rotary speaker.
REVERB
Reverb adds reverberation to the sound, simulating the acoustic
environment of a recital room, stage, or concert hall. There are six types
of reverb available. They are Room 1&2, Stage, Hall 1&2 and Plate.
SplitPoint=C2
Studio Grand
/Jazz Organ