Krell Industries DVD Player - Manual (Page 69)

Steps J– M. Install the HDMI Adapter PCB
J. Locate the HDMI connector on the back edge of the supplied HDMI adapter PCB
(not illustrated) and slide it into the HDMI connector through hole (6) on the back
panel (see Figure 3) of the Showcase DVD.
K. Secure the HDMI adapter PCB to the back panel using two supplied 4-40 x 1/4-
inch SHSC (7) (see Figure 3).
L. Position the left front through hole on the HDMI adapter PCB over the standoff
protruding up from the analog output board (not illustrated).
M. Thread one supplied 4-40 x 1/4-inch SHSC (28) onto the standoff to support the
front left corner of the HDMI adapter PCB (see Figure 4).
Steps N– P. Install the HDMI Power PCB
N. Mount the supplied HDMI power PCB onto the Showcase DVD chassis using the
four supplied 4-40 x 1/2-inch SHCS (8); one in each corner of the board. (see
Figure 4).
O. Secure the regulator to the chassis with the supplied 4-40 x 3/8-inch FHTS (9)
and cap it with the supplied 4-40 Kepnut (10) (see Figure 4).
P. Tighten until “just snug”. The torque spec is 5-8 in lbs.
7 6
Figure 3
Showcase DVD Back Panel
Showing HDMI Connector,
After HDMI Adapter PCB Is
Installed
6 Connector through hole with
HDMI connector in place
7 two 4-40 x 1/4-inch SHSC
4 Showcase DVD /
HDMI Upgrade
Audio sync switch