Kenwood KDW4TTSL - Manual (Page 8)

To fill the rinse agent dispenser, unscrew the dispenser cap located on the inner door (or on the
back of the tub). Add the rinse agent slowly into the container until it just reaches the bottom of
the filling cap inside the dispenser opening. Replace the cap.
Note: Remove large particles of food sediments before placing dishes in the dishwasher.
Note:
The machine can be used in hot water or cold water.
! CAUTION !
Water temperatures this high can cause severe burns/scalding. Always exercise extreme care
when opening and/or entering the dishwasher when the LCD display “High temperature”.
Operating Instructions
To operate the dishwasher:
1.
Make sure the inlet and drain hoses are correctly and securely connected.
2. Push the door release button to open the door.
3. Check to make sure that the filter is in the right position.
4. Place the dishes on the dish rack and cutlery inside the cutlery basket.
5. Check to make sure that the rotating spray arm can turn freely all the way round. If
necessary remove any obstacles.
6. Fill the detergent in the recessed area on inner door panel.
7. Close the door firmly
8. Open the water supply.
9. Push the power (on/off) button.
-Push Button in = power on
-Push Button out = power off
The LCD and the power light will illuminate indicating the machine is receiving power.
10.
Select the desired program by press the program key. The LCD will display the washing
mode which you selected.
Note: The LCD will display the default washing mode when it get the power. And if you
continuously choose some washing mode for three times, this mode will be default.
11.
Press the pause/start key to start. The LCD will flash the program and the washing state
during operation.
12. At the end of the cycle the dishwasher will stop, the LCD will stop flash, the dishwasher
will beep. The LCD will be black when the machine does not run or operate above 10
minutes. The power light remain illuminated, until the power (on/off) button is switched off.
13. The dishwasher is designed to stop if the door is opened accidentally during operation.
14. You can select another program during operation by pressing the pause/start key first,
then pressing the program key to the desired program, and pressing the pause/start key
to start.
15. After washing, dishes should be allowed to cool down for about 15 minutes so they are
not too hot to handle. Dishes will cool quicker if the door is opened slightly.
16. After unloading the dishwasher, remove the filter, clean off any bits of food, and put the
filter back in its position.
NOTE: At the beginning of each cycle, the dishwasher always starts in the “drain” mode. This is because
the drain pump always retains a small amount of water (in the sump) from the previous cycle. This is
necessary to keep the pump primed. Therefore, do not be alarmed if you see a small amount of water being
pumped-out from the drain hose prior to the start of the regular wash cycle (THIS IS NORMAL).
7