Lenoxx Electronics CT-992 - Manual (Page 11)

IB-CT992(NL)-WM-E-031103
PRECAUTIONS
On Safety
•
Should any solid object or liquid fall
into the set, disconnect the power, and
have it checked by qualified personnel
before operating it any further.
10
On Placement
•
Do not leave the set in a location
near heat source, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
•
Do not place the set on an inclined
or unstable place.
•
Do not place anything within 1 inch of
the back of the cabinet. The ventilation
holes must be unobstructed for the
set to operate properly and prolong
the life of its components.
•
If the set is left in a car parked in
the sun, be sure to choose a location
in the car where the set will not be
subjected to the direct rays of the sun.
•
Since a strong magnet is used for the
speakers, keep personal credit cards
using magnetic coding or spring-
wound watches away from the set
to prevent possible damage from the
magnet.
Notes on Cassette
Side A
Tab for side A
Tab for side B
•
California Proposition 65 Warning:
This product contains chemicals known
to the state of California to cause cancer,
and birth defects or other reproductive
harm.
Wash Hands After Handling.
On Power Sources
•
For battery operation, use 4 size “C”
batteries. We recommend alkaline
batteries for longer life.
•
When the batteries are not to be used,
remove them to avoid damage that can
be caused by battery leakage or
corrosion.
•
The nameplate indicating operating
voltage, power consumption, etc. is
located at the back of the set.
•
Break off the cassette tab from side A or
B to prevent accidental recording. If you
want to reuse the tape for recording,
cover the broken tab with adhesive tape.
•
To record on a tape with its tab broken
off, cover the respective tab hole for side
A or B with adhesive tape.
•
Use of a cassette with more than 90
minutes, such as C-120 (120
minutes), is not recommended. The
extreme thinness of this tape may
damage this set.
•
To reduce the chances of tape jamming
or tangling, you should check that there
are no loose layers of tape visible
through the cassette center window. If
any, tighten these loose layers of tape
using a pencil before inserting the
cassette into the set.
CT-992(NL)-WM-E-031103.p65 3/12/03, 11:00 AM 11