Liebert EC FAN CW076 THRU CW114 - Manual (Page 2)

DPN002037
REV 5
REV 7/10
PAGE 2 OF 3
6. USING THE FACTORY SUPPLIED JACK
AND CRANK, LOWER THE FAN MODULE
UNTIL IT RESTS ON THE FRAME OF THE UNIT.
USE CAUTION TO PREVENT DAMAGE
TO THE FAN WIRE HARNESS.
7. CW026, CW038, CW041, CW076 THRU CW114 MODELS:
USING THE HARDWARE REMOVED IN STEP 5,
RE-INSTALL "Z" BRACKETS WITH HEX-HEAD
SCREWS TO RETAIN FAN MODULE IN THE FULLY
LOWERED POSITION.
CW051 AND CW060 MODELS:
USE THE HEX-HEAD SCREWS REMOVED IN
STEP 5 TO SECURE THE FAN MODULE DIRECTLY
TO THE CENTER FRAME SUPPORT. SCREW
CLEARANCE HOLES ARE PROVIDED IN THE FAN
MODULE. THE "Z" BRACKETS WILL ONLY BE USED
TO SECURE THE FAN AT THE OUTTER
ATTACHMENT POINT.
LIEBERT DS, CW146 AND CW181 MODELS:
USE THE HEX HEAD SCREWS REMOVED IN STEP 5
TO SECURE THE FAN MODULE DIRECTLY TO
THE FRAME. SCREW CLEARANCE HOLES ARE
PROVIDED IN THE FAN MODULE.
NOTE: NOT ALL HARDWARE REMOVED IN STEP 5 WILL
BE USED TO RETAIN FANS IN LOWERED POSITION.
8. REPEAT STEPS 3-7 TO LOWER REMAINING FAN
MODULE(S) IF PRESENT.
NOTE: THE FANS MUST BE OPERATED IN EITHER
THE FULLY RAISED POSITION OR FULLY LOWERED
POSITION. NO OTHER COMBINATION OF FAN
POSITIONING IS SUPPORTED.
C C
SECTION C-C
6
FAN DECK AND SIDE PANELS
NOT SHOWN IN THIS VIEW
6
6 FAN MODULE
RESTING ON FRAME
7 7
"Z" BRACKETS