Lanzar Car Audio Lanzar Vibe VBD2600MP - Manual (Page 14)

E - 13
Manual Tuning
Press the Up Tuning or Down Tuning button for more than 3 seconds to move the radio
frequency number up or down one step.
Auto Seek Tuning
Press the Up Tuning or Down Tuning button for less than 3 seconds to move to next station
automatically.
6. TUNER OPERATION
Recall a Station
Select a band (if needed). Press a preset button to select the corresponding stored station.
8) BAND BUTTON (BAND/SERACH)
Press BAND to change between FM bands and AM(MW) bands. Each band stores
up to 6 preset stations.
10) TUNING UP/DOWN BUTTON ( )
11) SCAN BUTTON(SCAN)
Press SCAN button to scan through strong stations in the current band. The radio pauses
for 5 seconds at each strong station. Press SCAN button again to listen to the current
station.
12) PRESET STATIONS BUTTON
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Hold a preset button for 3 seconds. The
preset number will appear in the display.
Automatically Store
Automatically select 6 strong stations and store them in the current band. Select a band (if
needed). Press AS/PS button for more than three seconds. The new stations replace
stations already stored in that band.
Preset Scan
Scan stations stored in the current band. Select a band (if needed). Press AS/PS button for
less than 3 seconds. The unit will pause for ten seconds at each preset station. Press
AS/PS button again to stop scanning when the desired station is reached.
STEREO
The unit will automatically pick up a stereo signal, when available. When in stereo mode,
the ST icon appears in the display. When no stereo signal is available, the unit will
automatically revert to mono operation, and no icon will be displayed.
13) AUTOMATICALLY STORE / PRESET SCAN (AS/PS)
This feature is used to designate the strength of the signals at which the radio will stop
during automatic tuning. "Distance" is the default, allowing the radio to stop at a broader
range of signals. To set the unit to select only strong local stations during automatic
tuning,press this button until "Local" appears in the display.
17) LOCAL / DISTANCE BUTTON(LO/DX)