Lux Products SMART TEMP TX9100E - Manual (Page 20)

20
needed. With the Fan switch in the ON position, the fan will
operate even when the Temperature Mode switch is in the
OFF position to provide air circulation only. When the fan is
running, the word “FAN” is displayed in the temperature
portion of the display screen.
NOTE:
The Fan Mode switch only works if your system provides a
wire for the thermostat’s “G” wire terminal, to control a
blower fan. The Fan Mode switch has no effect in systems
that do not have a blower fan (such as a hot water radiator
system).
PUSH BUTTONS
There are five primary push buttons on the front of the
thermostat: The UP and DOWN arrow keys, the NEXT button,
The HOLD button, and the COPY/EMER button.
ROTARY DIAL
The LUX Speed Dial
® provides an easy way to quickly
navigate between the different programming areas. This
rotary dial has five individual positions and should always
remain in the RUN position, unless a specific action is being
performed in one of the other positions.
11. OPERATING INSTRUCTIONS
SET DAY/TIME
Rotate the dial to the SET DAY/TIME position. You should
see the word SET appear in the upper left corner of the
display, along with the clock and a day of the week that is
flashing. With the day flashing, press either the UP or
DOWN buttons to make the current day flashing. Press the
NEXT button; this should cause the time to start flashing and
the day to remain on steady. Using either the UP or DOWN