Lincoln 2011 MKS - Manual (Page 96)

• Continue to press and hold the HomeLink௡ button (note Step 2 in the
Programming section) while you press and release — every two
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
௡. The indicator light will
flash slowly and then rapidly after HomeLink
௡ accepts the radio
frequency signal.
• Proceed with Step 3 in the Programming section.
Operating the HomeLink
ா Wireless Control System
To operate, simply press and release
the appropriate HomeLink
௡ button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink
௡ at www.homelink.com or
1–800–355–3515.
Erasing HomeLink
ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.
Driver Controls
96
2011 MKS (mks)
Owners Guide, 1st Printing
USA (fus)