Land Pride 322-215M - Manual (Page 13)

11
Section 2: Adjustments
5/29/13 Model SBR72 Seed Bed Roller 322-215M
Table of Contents
Scraper Bar Adjustment
Refer to Figure 2-1:
1. Slightly loosen hex nuts (#3) on both ends of the
scraper bar (#1). Nuts should be loose enough to
allow scraper bar movement but tight enough to hold
the scraper bar in place until nuts have been
retightened.
2. Adjust scraper bar (#1) left or right to center scraper
teeth (#A) in the roller flutes and up or down until the
teeth just clear the bottom of the roller flutes. Some
light tapping with a hammer against a properly
placed block of wood may be required to move the
scraper bar.
3. Tighten 3/8"-16 nuts (#3) to the correct torque. Refer
to “Torque Values Chart For Common Bolt Size”
on page 21.
Ball Hitch Swivel Adjustment
Refer to Figure 2-2:
1. Hold plate (#1) from turning and tighten hex flange
nut (#3) until plate (#1) is against plate (#2).
2. Rotate ball hitch about plate (#2) by hand. If ball hitch
will not rotate, back nut (#3) off until it will rotate.
IMPORTANT: Scraper bar must be adjusted with
rear roller resting on the ground to ensure roller
rings are in their upper most position.
IMPORTANT: Tapping with a hammer may be
required to move scraper bar (#1). When doing so,
be sure to place a block of wood in the area to be
tapped. Tap hammer against the wood and not the
scraper bar to help protect the finish.
IMPORTANT: Hex flange lock nut (#3) should be
adjusted tight enough so that the two mating plates
(#1 & #2) make contact but loose enough so that the
plates can rotate against each other.
A 16" long socket extension and 1 1/8" hex socket will
be required to reach the 3/4" hex flange nut (#3).
Scraper Adjustment
Figure 2-1
Ball Hitch Swivel Adjustment
Figure 2-2
25784
25785
Insert Socket Extension
In This Opening
Section 2: Adjustments