Lanier LD075 - Manual (Page 21)

Placing Originals
13
1
Placing Originals on the
Exposure Glass
Reference
Related Initial Settings
⇒ p.108
“Eject Copy Face Up/Down in
Glass”
AAAA
Lift the exposure glass cover or
the document feeder.
Important
❒ Do not open the exposure glass
cover or the document feeder
forcefully. Otherwise, the cover
of the document feeder might
open or be damaged.
Note
❒ Be sure to open the exposure
glass cover or the document
feeder by more than 30
°. Other-
wise, the size of the original
might not be detected correctly.
BBBB
Place the original face down on the
exposure glass. The original should
be aligned to the rear left corner.
1. Reference mark
2. Left scale
Note
❒ Start with the first page to be
copied.
CCCC
Lower the exposure glass cover or
the document feeder.
Placing Originals in the
Document Feeder
Settings should be made in the fol-
lowing situations:
❖ ❖ ❖ ❖ When placing originals one by one:
⇒ p.15 “SADF mode”
❖ ❖ ❖ ❖ When placing originals consisting of
more than 100 pages:
⇒ p.14 “Batch mode”
❖ ❖ ❖ ❖ When copying originals of various
sizes:
⇒ p.15 “Mixed Size mode”
❖ ❖ ❖ ❖ When placing custom size originals:
⇒ p.16 “Placing Custom Size Orig-
inals”
Note
❒ Do not stack originals beyond the
limit mark on the side fence of the
document feeder.
❒ The last page should be on the bot-
tom.
❒ When you copy 2–sided originals,
both front and back sides of each
original are scanned at once.
❒ Do not place any foreign objects on
the sensors or cover them with
your hands. This could cause a
malfunction or the size to not be
detected properly.
1. Sensors
MartiniC1_GBcopy4_FM.book Page 13 Tuesday, April 23, 2002 6:23 PM