Lenoxx Electronics PH-3235 - Manual (Page 7)

IB-PH3235(MS)-WM-E-122203
This set is designed
to connect directly
to a modular jack
If you have a 4-prong
style jack, simply use a
modular adaptor (not
included).
MODULAR JACK
TELEPHONE LINE
(4-prong style jack)
6
INSTALLATION INSTRUCTIONS
INSTALLATION
HANDSET
COILED HANDSET CORD STRAIGHT TELEPHONE CORD
To Telephone Jack
TELEPHONE BASE
1. Insert the modular plugs of the COILED HANDSET CORD into the jack of the
TELEPHONE HANDSET and into the jack on the left side of the TELEPHONE BASE.
2. Insert the modular plugs of the STRAIGHT TELEPHONE CORD into the modular jack at
the REAR of the TELEPHONE BASE and into the TELEPHONE WALL JACK (either end
can be plugged in).
RINGER SETTING
This switch is located on the rear of the set. Select the desired function of the ringer.
HI - Loud rings on incoming calls.
LOW - Lower rings on incoming calls.
OFF - No rings on incoming calls.
NOTE: If your RINGER switch is in OFF position, only THIS phone will not ring, other
phones in your home on the same line will ring.
TONE/PULSE SWITCH
Select the type of dialing that you desire or that your telephone system requires.
TONE - The phone will operate using tone dialing. (If your phone doesn’t dial out,
switch to PULSE.)
PULSE - The phone will dial using rotary pulse dialing.
NOTE: Even when your phone is set to pulse service, this phone can be switched to
temporary tone dialing for access to services that require tone signaling like
computer systems. Just press the button after dialing in pulse and your
buttons can now be used for tone signaling for this call only.
NOTE: When installation is completed, pick up the HANDSET to listen for dial tone
before using speakerphone or headset for the first time.
IB-PH3235(MS)-WM-E-122203 .p65 12/27/02, 12:43 PM 7