Land Pride Razor Harness Update Kit 356-142A User Manual

Page 2

Advertising
background image

2

Manual No. 356-141M

1/16/07

Land Pride

Instructions For Kit No 356-142A

Refer to Figure 3:
6.

Locate main wiring harness attached to the mower
frame. Cut plastic ties securing harness in place.

Locate Wire Harness

Figure 3

Refer to Figure 4:
7.

Pull white connector out from under back right corner
of mower frame.

8.

Unplug connector by pressing down on the center
tab and pulling the two ends apart.

Unplug Connector

Figure 4

Refer to Figure 5 & Figure 6:
9.

Locate two purple ground wires leading from the
connector to the main wiring harness.

Remove Purple Ground Wires

Figure 5

Main Wiring
Harness

23813

Plastic Tie

Mower Frame

Male End

23814

Press Here to
Unplug Connector

Female End

23815

Purple Wire

Backside of
Connector

Main Wiring
Harness

10. Insert terminal removal tool or small thin bladed

screw driver into backside (see Figure 5) of a purple
wire connector slot. Push in on the purple wire and
press down on the holding tab. See Figure 6 below
for view of holding tab. Once the tab has released,
pull purple ground wire out. If the terminal does not
release, reposition terminal tool and pull on the wire
again.

Spade Terminal Holding Tab

Figure 6

11. Repeat step 10 to remove second purple ground

wire.

Refer to Figure 7:
12. Cut both purple wires close to the spade terminals.

Cutting close will leave enough wire to install butt
connector in step 13 below.

Cutting Spade Terminals Off

Figure 7

Refer to Figure 7:
13. Strip 3/8" length of outer covering from both ends of

purple ground wires. Twist wire ends together and
twist-on butt connector.

Installing Butt Connector

Figure 7

Spade Terminal Holding Tab

24595

23816

Spade
Terminals

Wire Cutters

Cut Close
to Spade
Terminals

23819

Butt
Connector

Main Wiring
Harness

Two Purple
Ground Wires

Advertising