Lenovo THINKSERVER 3821 User Manual
Hardware maintenance manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Chapter 1. About this manual
- Chapter 2. Safety information
- Chapter 3. General information
- Chapter 4. General Checkout
- Chapter 5. Diagnostics
- Diagnostic tools
- Event logs
- POST error codes
- System-event log
- Integrated management module error messages
- Troubleshooting tables
- DVD drive problems
- General problems
- Hard disk drive problems
- Intermittent problems
- Keyboard, mouse, or pointing-device problems
- Memory problems
- Microprocessor problems
- Monitor problems
- Optional-device problems
- Power problems
- Serial port problems
- Software problems
- Universal Serial Bus (USB) port problems
- EasyLED diagnostics
- Diagnostic programs, messages, and error codes
- Recovering from a Lenovo ThinkServer Server Firmware update failure
- Solving power problems
- Solving Ethernet controller problems
- Solving undetermined problems
- Problem determination tips
- Chapter 6. Locating Server Controls and connectors
- Chapter 7. Installing optional devices and replacing customer replaceable units
- Server components
- Opening the bezel
- Closing the bezel
- Removing the bezel
- Installing the bezel
- Opening the bezel media door
- Closing the bezel media door
- Removing the left-side cover
- Installing the left-side cover
- Opening the power-supply cage
- Closing the power-supply cage
- Turning the stabilizing feet
- Internal cable routing and connectors
- Removing the air baffle
- Installing the air baffle
- Removing the fan-cage assembly
- Installing the fan-cage assembly
- Removing the battery
- Installing the battery
- Removing a hot-swap power supply
- Installing a hot-swap power supply
- Installing redundant power supply and fans
- Removing a voltage regulator module
- Installing a voltage regulator module
- Removing the front adapter-retention bracket
- Installing the front adapter-retention bracket
- Removing the rear adapter retention bracket
- Installing the rear adapter retention bracket
- Removing an adapter
- Installing an adapter
- Removing the DVD drive
- Installing a DVD (optical) drive
- Removing an optional tape drive
- Installing a USB or SATA tape drive
- Removing the USB cable and EasyLED panel
- Installing the USB cable and EasyLED panel
- Removing a 2.5-inch hot-swap hard disk drive
- Installing a 2.5-inch hot-swap hard disk drive
- Removing a 2.5-inch disk drive backplane
- Installing a 2.5-inch disk drive backplane
- Removing the 2.5-inch disk drive cage
- Installing the 2.5-inch disk drive cage
- Removing the operator information panel assembly
- Installing the operator information panel assembly
- Removing an extender card
- Installing an extender card
- Removing a memory module
- Installing a memory module
- Removing a hot-swap fan
- Installing a hot-swap fan
- Removing a microprocessor and heat sink
- Installing a microprocessor and heat sink
- Removing a heat-sink retention module
- Installing a heat-sink retention module
- Removing a microprocessor retention module
- Installing a microprocessor retention module
- Removing the system board
- Installing the system board
- Completing the installation
- Chapter 8. Parts Listing, TD200x Machine Types 3719, 3821, 3822, and 3823
- Chapter 9. Configuring the server
- Using the Setup Utility
- Using the Boot Selection Menu program
- RAID controllers
- Using the ThinkServer EasyStartup DVD
- Enabling the Broadcom Gigabit Ethernet Utility program
- Configuring the Gigabit Ethernet controller
- Updating the firmware
- Starting the backup server firmware
- Using the Integrated Management Module
- Using the remote presence capability and blue-screen capture
- Advanced Settings Utility program
- Installing ThinkServer EasyManage software
- Appendix A. Getting help and technical assistance
- Appendix B. Notices
- Trademarks
- Important notes
- Product recycling and disposal
- Compliance with Republic of Turkey Directive on the Restriction of Hazardous Substances
- Recycling statements for Japan
- Battery return program
- German Ordinance for Work gloss statement
- Electronic emission notices
- Federal Communications Commission (FCC) statement
- Industry Canada Class A emission compliance statement
- Avis de conformité à la réglementation d′Industrie Canada
- Australia and New Zealand Class A statement
- United Kingdom telecommunications safety requirement
- European Union EMC Directive conformance statement
- Germany Class A compliance statement
- Japan Voluntary Control Council for Interference (VCCI) statement
- Taiwan Class A warning statement
- People′s Republic of China Class A warning statement
- Korea Class A warning statement
- Index