Liebherr WS 40 - Manual (Page 10)

O
PERATION
Setting the Temperature
- Figure 7
The temperature of both compartments can be set
separately.
To reduce the temperature: Press the  “DOWN“
button;
- on the left for the upper compartment, on the
right for the lower compartment.
To increase the temperature: Press the  “UP“
button.
- While you are entering the temperature, the set
temperature will flash on the display.
- You can change the settings in increments of
1°F (1°C) by briefly pressing the button again.
The electronic controls will switch over automati-
cally about five seconds after the last time you
pressed the button. The actual temperature dis-
plays.
Figure 7
If F0 or F1 appears in the display, the appliance has
a fault. Contact your nearest customer service rep-
resentative, indicate the type of appliance, index
and Appliance / serial number.
Ventilation Button
- Figure 8
Should you wish to use the wine cooler to
store wine for long periods of time, activate the
“Ventilation“ button. The light in the button comes
on and the ventilation function is active. Then the
climate which corresponds to that of a wine cellar
is achieved inside the wine cooler. Bottle corks are
prevented from drying out due to an increased level
of humidity.
Figure 8
Operating and
Control Elements
- Figure 5
Figure 5
1. Lower compartment temperature display
2. Upper compartment temperature display
3. Lower compartment temperature setting buttons
4. Upper compartment temperature setting buttons
5. Alarm ON/OFF button
6. Interior light ON/OFF button
7. Childproof Lock
8. ON/OFF button
9. Ventilation button
Turning the Appliance
ON and OFF
- Figure 6
Clean the appliance before turning it on for the first
time. See Cleaning. Connect the appliance to the
dedicated outlet - the appliance is turned on.
The alarm will sound when the appliance is turned
on for the first time and when the appliance is
warm. Press the Alarm button to turn it off. The
temperature display will also flash.
• To turn the appliance off: Keep the ON / OFF
button pressed for three seconds so that the
temperature display goes out.
• To turn the appliance on: Press the ON / OFF
button until the display lights up.
Figure 6
10