Lenovo WIDE FLAT PANEL MONITOR L2262 - Manual (Page 8)

Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
1. Power off your computer and all attached devices, and unplug the computer
power cord.
Place the cable into the specific hook indicated in below figure.
3. Connect the digital cable to the DVI connector of the monitor and the other end
on the back of the computer.
Place the cable into the specific hook indicated in below figure.
Chapter 1.
1- 4
Note: Be sure to read the Safety information located on page iii before
carrying out this procedure .