Installation, Warning – Lincoln Electric AUTODRIVE 4R220 User Manual

Page 14

Advertising
background image

A-7

INSTALLATION

AutoDrive™ 4R220

A-7

CONDUIT INSTALLATION

The K1546-xx series of conduits are compatible with
K515-xx, K565-xx, Wire Wizard and Electron Beam
Technologies conduits.

To install conduit to the wire drive:

1. Slide the conduit bushing into the feed plate and

secure with the set screw.

2. Slide the conduit into the bushing and lock in

place with the thumb screw.

CONDUIT

CONDUIT
BUSHING

THUMB
SCREW

SET
SCREW

PRESSURE ARM ADJUSTMENT

ELECTRIC SHOCK can kill.

• Turn the input power OFF at the weld-

ing power source before installation or
changing drive rolls and/or guides.

• Do not touch electrically live parts.

• When inching with the gun trigger, electrode

and drive mechanism are "hot" to work and
ground and could remain energized several sec-
onds after the gun trigger is released.

• Do not operate with covers, panels or guards

removed or open.

• Only qualified personnel should perform mainte-

nance work.

------------------------------------------------------------------------

The pressure arm controls the amount of force the
drive rolls exert on the wire. Proper adjustment of the
pressure arm gives the best welding performance.

Set the pressure arm as follows:
(See Figure A.3)

Aluminum wires

between 1 and 3

Cored wires

between 3 and 4

Steel, Stainless wires

between 4 and 6

LOADING WIRE

• Keep hands, hair, clothing and tools

away from rotating equipment.

• Do not wear gloves when threading wire

or changing wire spool.

• Only qualified personnel should install,

use or service this equipment.

------------------------------------------------------------------------

WARNING

WARNING

FIGURE A.3

Advertising