Lucent Technologies P333T - Manual (Page 6)

5
Basic configuration
To connect a PC terminal or VT-100 terminal to the Cajun P330
1. If you are using a PC, initiate a VT-100 terminal emulation session using an application
such as Windows® HyperTerminal.
2. Press Enter.
K The Welcome to Cajun P330 menu is displayed.
3. Type the User name root when prompted and press Enter.
4. Type the User Level password root when prompted and press Enter.
K The Cajun_P330-N(super)# prompt appears
E N is the number of the switch in the stack.
Assigning the Stack IP Address
E Commands are shown as follows: set interface inband;
parameters which you need to enter are shown in <> as follows: <vlan>
1. Type set interface inband <vlan> <ip_address> <netmask>, replacing
<vlan>, <ip_address>
and <netmask> with the VLAN, IP address and net mask of
the stack and press Enter.
2. Press Enter to save the VLAN, IP address and net mask.
3. Type reset and press Enter to reset the stack at the Cajun_P330-N# prompt
4. After the Reset, perform login to Privileged level again as described in step 1.
K The Cajun_P330-N(super)# prompt appears.
5. Type set ip route <dest> <gateway>, replacing <dest> and <gateway> with the
destination and gateway IP addresses and press Enter.
6. Press Enter to save the destination and gateway IP addresses.
Cajun P333T QS.qxd 18/07/2000 12:09 Page 6