La Crosse Technology WS-9029U - Manual (Page 7)

7
To view minimum and maximum temperatures: press the min/max/+ button once. “MIN” appears in
the bottom left of the LCD. The indoor and outdoor temperatures displayed when “MIN” appears are
the minimum recorded values. The minimum records will display for 30 seconds before returning to
the normal display mode.
Press the min/max/+ button again (once while “MIN” is still displayed, twice otherwise). “MAX”
appears in the bottom right of the LCD. The indoor and outdoor temperatures displayed when “MAX”
appears are the maximum recorded values. The maximum records will display for 30 seconds before
returning to the normal display mode.
While “MAX” is still displayed press the min/max/+ button again to return to the current data display.
Or you can wait 30 seconds, during either the minimum or the maximum readings, and the unit will
automatically return to current data readings.
RESETTING THE MIMIMUM AND MAXIMUM RECORDS
All the minimum and maximum records (minimum and maximum) will be reset after the min/max/+
button is pressed and held for 5 seconds.
OPTIONAL CHANNEL 2 TEMPERATURE PROBE
When the temperature probe is connected to the remote temperature sensor, the WS-9029U’s
channel 1 will display the remote temperature sensor data, and channel 2 will display the temperature
probe data. The remote temperature sensor data will always be displayed on the channel 1 and the
temperature probe on the channel 2.
If the probe on remote temperature sensor is unplugged, the "probe channel" on WS-9029U LCD will
show "---", the remote temperature sensor displayed value will still be shown.
The probe can be connected to the remote temperature sensor anytime. There is no need to reset the
units. The Weather Station will automatically detect the temperature probe and will display the
temperature probe data in channel 2.
ADDING TEMPERATURE SENSORS (OPTIONAL)
The WS-9029U is able to receive signals from 2 remote temperature sensors (TX-25U). These extra
sensors can be purchased through the same dealer as this unit
A. SET-UP OF MULTIPLE SENSORS
1. Remove all the batteries from the receiver and sensor(s) and wait 60 seconds. During these
60 seconds, press any button 20 times to discharge any excess power.
2. Insert the batteries to the first sensor.
3. Within 2 minutes of powering up the first sensor (Temperature sensor with probe), insert the
batteries to the Weather Station. Once the batteries are in place, all segments of the LCD will
light up briefly. Following the indoor temperature/humidity and the time as 12:00 will be
displayed, and the signal reception icon will flash. If they are not shown in LCD after 60
seconds, remove the batteries and wait for at least 60 seconds before reinserting them.
4. The outdoor temperature from the first sensor (channel 1) should then be displayed on the
Weather station. If this does not happen after 2 minutes, the batteries will need to be removed
from both units and reset from step 1.
5. If the temperature probe has been used, the outdoor temperature from channel 2 will then be
displayed. Otherwise, the outdoor temperature will display “---“.
Note: The temperature probe from the first sensor will always occupy “channel 2”. Channel 2 can
only be used for the temperature probe. If you choose not to use the temperature probe, Channel
2 will display “---“.
6. Insert the batteries to the second sensor as soon as the outdoor temperature readings from
the first sensor are displayed on the Weather station.