Lowrance electronic Electronic Speed Sensor EP-70R - Manual (Page 13)

13
4. Press
ENTER
. Use the arrow keys to input the desired name for the
speed sensor and press
ENTER
. Press
EXIT
repeatedly to return to the
main display.
To reset device name to default setting:
1. Press
MENU
twice, select
NMEA 2000
or
N
ETWORKING
and press
ENTER
. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
B
US
S
ETUP
and press
ENTER
, to open the Bus Configuration
menu. A list of network devices will be at the top of the page.
3. Select the desired speed sensor and press
ENTER
. The Device
Configuration menu will appear with the Device Name dialog box
highlighted.
4. Press
ENTER
. Depress the left arrow key until the device name
disappears. Press
ENTER
, then press
EXIT
to return to the NMEA 2000
menu.
5. Highlight the device and press
ENTER
. The Device Configuration
menu will open. The device name will be reset to its default setting.
Press
EXIT
repeatedly to return to the main display.
Restore Defaults
Located on the Advanced Options menu, the Restore Defaults
command allows you to reset an EP-70R Speed Sensor's settings to
factory defaults.
To restore default settings:
1. Press
MENU
twice, select
NMEA 2000
or
N
ETWORKING
and press
ENTER
. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
B
US
S
ETUP
and press
ENTER
, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select EP-70R Speed and press
ENTER
. The Device Configuration
menu will appear.
4. Highlight
A
DVANCED
O
PTIONS
and press
ENTER
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENTER
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENTER
. Press
EXIT
repeatedly to return to
the main display.