Knekt rcu operation – Linn KNEKT Multi-room User Manual
Page 11
English
KNEKT Multi-room
Owner's Manual
KNEKT RCU operation
Clock feature
T
To
o d
diis
sp
plla
ay
y tth
he
e c
cllo
oc
ck
k::
●
Press
repeatedly to step you through the clock display options
available – i.e. time with seconds; time without seconds; date; day and
time.
T
To
o s
se
ett tth
he
e c
cllo
oc
ck
k::
●
Press
, and then
and D
DO
O simultaneously.
The display shows the current time, with the hours flashing.
●
Use the ‘‘m
mu
ullttii--ffu
un
nc
cttiio
on
n’’ keys to change the value of the flashing number,
or D
DO
O to select the next time or date field.
●
When you have set the required time and date, press
to store the
new values and start the clock. Pressing any other key cancels the
changes you have made, and restores the original time and date.
Note:
When the time is updated, any alarm settings stored in the KNEKT RCU (see the
Alarm Function section later in this manual) will be cancelled.
To perform a system clock update (INTERSEKT based systems only):
If your KNEKT system incorporates the INTERSEKT, at the end of the above
sequence the following display will appear:
‘System time update?’
And the ‘X’ ‘ ’ options will appear above the ‘‘m
mu
ullttii--ffu
un
nc
cttiio
on
n’’ keys.
●
Press the right hand ‘‘m
mu
ullttii--ffu
un
nc
cttiio
on
n’’ key (below the ‘ ’ ), to update all
KNEKT RCU clocks in the system.
OR
●
Press the left-hand ‘‘m
mu
ullttii--ffu
un
nc
cttiio
on
n’’ key (below the ‘X’), to update only the
KNEKT RCU in that room.
C
Co
on
nttrro
olllliin
ng
g tth
he
e K
KN
NE
EK
KT
T s
sy
ys
stte
em
m b
by
y rre
em
mo
otte
e c
co
on
nttrro
oll
If you have a Linn remote control handset that includes the W
WH
HE
ER
RE
E, W
WH
HA
AT
T, D
DO
O
and ‘‘m
mu
ullttii--ffu
un
nc
cttiio
on
n’’ keys, then this can be used to control the KNEKT RCU. Use
these keys exactly as you would use the equivalent keys on the KNEKT RCU
(see
KNEKT RCU operation, above).
The KNEKT RCU’s standard preamplifier functions (volume +/-, mute, balance
etc) can also be controlled, using the corresponding keys on the handset.
Note:
If your KNEKT RCU does not respond to the KNEKT commands from the remote
control, please check firstly that the remote control handset is functioning
(perhaps check it using another Linn product). If the handset is functioning but
will not control the KNEKT RCU, it may be that the KNEKT RCU has been
programmed so that its remote control sensor is disabled. Please consult your
Linn Custom Installer.
8