Lucent Technologies 03.0.042.2 - Manual (Page 11)

Change Descriptions
Issue 1 July 2000 9
43. The administration field used to administer a user-translated version of the
display message viewed when you use the button view feature on the
DID-view button was located on the display-messages
property-management form. The field is now located on the
display-messages view-buttons form. Only the first 24 characters of the
user-translated button view display message for the DID-view button are
retained. The last 16 characters are truncated.
44. When displaying the contents of an autodial button with a Button View
button, special characters such as "pause" did not display correctly. In
addition, characters following a "suppress special" character did not
suppress in the button view display.
45. A station with a manual exclusion soft key administered beeped when
calling a busy destination.
46. A user calling a DECT unit that was not reachable had to wait for the full
"doesn’t answer" timeout before covering or forwarding, rather than
covering or forwarding as soon as the unit was determined to be
unreachable.
47. Under heavy traffic load, if numerous (50 or more) stations went off-hook at
about the same time (10 second window) and were directed to the
attendant via the Emergency Access feature the system might reset.
48. Automatic Route Selection (ARS) calls that were administered to route
immediately were incorrectly delayed by a 3 second inter-digit timer.
49. With Centralized Voice Mail via Interswitch Mode Code, if the switch did not
have a Uniform Dial Plan (UDP) then the proper digits were not being
delivered to the Voice Mail System (VMS) (AUDIX or OCTEL) for internal
and external coverage calls. The proper digits are now delivered to the
VMS even if UDP is not enabled. The only difference is in the mode code
that is sent. If UDP is enabled then the mode codes #02 or #03 are sent. If
UDP is not enabled then only the mode code #03 is sent.
50. Calls to Computer Telephony Integration (CTI) type stations did not go to
coverage when Send All Calls (SAC) was activated.
51. When Trunk Answer Any Station (TAAS) was used outside of night service
on attendant vectored calls, the calls were not dropped from the attendant
queue.
52. Trying to remove an AWOH station with a Ringer Cutoff button active
failed; this failure happened only if Terminal Translation Initialization (TTI)
was NOT enabled in the system.
53. Calls to a VDN that terminated to an attendant split displayed the wrong
information on the console if the vector had an announcement step prior to
queueing the call to the split.
54. It was possible to remove a hunt group, even if its extension was
administered as the “VMS Hunt Group Extension” on the system-param
mode-code form. Also, the command "list usage extension” did not show
the hunt group extension, as used on the mode-code form.