Lincoln Electric BULLDOG TM 140 IM10005 - Manual (Page 13)

A-6 INSTALLATION
BULLDOG™ 140
A-6
PREMISES WIRING
The BULLDOG™ 140 is not recommended for
premises wiring.
The BULLDOG™ 140 does not have a combined
120/240 volt receptacle and cannot be connected to
a premises as described in other Lincoln literature.
Remember that the BULLDOG™ 140 is intended only
for backup, intermittent use power.
Certain electrical devices cannot be powered by the
BULLDOG™ 140. Refer to Table A.2 for these
devices.
CIRCUIT BREAKERS
Auxiliary power is protected by circuit breakers.
When the machine is operated in high temperature
environments, the breakers may tend to trip at lower
loads than normally.
Never bypass the circuit breakers. Without over-
load protection, the BULLDOG™ 140 could over-
heat and/or cause damage to the equipment being
used.
-------------------------------------------------------------
CAUTION