La Crosse Technology WT-8005U - Manual (Page 5)

Page 5 of 12
•
Press “SET” to confirm your setting, the Date
display starts to flash. Now use “▲” and “▼“
buttons to set the correct date. Weekday will
set itself if the clock has received the WWVB
signal.
•
Press “SET” to confirm your setting, the DST
icon starts to flash. Now use “▲” and “▼“
buttons to turn Daylight Saving Time on ("on")
or off ("oF"). See "Daylight Saving Time"
below for more information.
•
Press “SET” to confirm your setting and to end
the setting procedures, enter the clock mode.
Daylight Saving Time
•
The National Institute of Standards and
Technology and WWVB encode a special DST
“bit” in the WWVB transmission for DST.
•
Your La Crosse Technology® clock will read
this information (only if "DST" is set to "on" -)
and automatically advance the time one hour in
the spring and back an hour in the fall.
•
Arizona: If you live in an area that does not
recognize DST you must de-activate Daylight
Saving Time by setting "DST" to "oF"
Setting the Time Zone:
•
Press the “▲” button to set the correct time
zone. It will toggle the clock mode through the
four available time zones in the Continental
U.S. Above the seconds digits, the LCD display
will indicate "P" for Pacific, "M" for Mountain,
"C" for Central and "E" for Eastern.
•
After 30 seconds without pressing any button,
the clock switches automatically from set mode
to normal time mode.
Setting the Daily Alarms:
•
To turn the alarm on, press the ALARM button.
LCD displays the “” icon.