Liebert Air Flow Enhander XDA - Manual (Page 8)

4
2.3.2 Mount the Unit and Attach it to the Cabinet
1. Lift the unit with bracket attached and hang it on the door, as
shown at right. Ensure that the bracket rests safely on top of the
top edge of door.
2. Move the unit sideways into the desired position. Ensure that the
unit does not interfere with operation of the door latch.
3. Place screws through the middle and lower mounting holes of the
XDA mounting angle and then through the door. Place nuts on the
screws and tighten them.
4. Remove the nuts that attach the bracket to the unit and remove
the bracket.
5. Lean the top of the unit slightly away from the door and remove
the screws.
6. Install screws in the top holes in the same manner as in the mid-
dle and bottom holes. Tighten all nuts and screws.