La Crosse Technology WS-9018U - Manual (Page 6)

6
6. Setting up:
Activating the Sensor(s):
1. Using a screwdriver, unscrew and open the battery cover located at the front of the sensor.
2. Insert 2 x AA 1.5V batteries into the battery compartment being sure to observe the correct
polarity marked inside the battery compartment.
3. Once the batteries are inserted, the LCD on the sensor will show the surrounding temperature
and humidity and start transmitting the data to the receiver by 433MHz.
4. Replace the battery cover and screw.
Activating the Receiver:
1. Flip open the battery cover located at the back of the receiver and checking the correct
polarization, insert 2 x AA 1.5V batteries into the battery compartment before replacing the
cover
2. Once the batteries are inserted, all the LCD segments will light up briefly before displaying
individual sets of data
7. How to use the Weather Station:
This section will describe how to interpret the data as shown on the LCD of the Weather Station. For easy reference, the
LCD shown here is in full segment.