Call park support – Linksys LVS 9000 User Manual
Page 57
© 2006 Cisco Systems, Inc. All Rights Reserved.
Linksys/Cisco Proprietary – All Content Subject To Change – Not a Warranty
57
Call Park Support
•
Call Park and Call Un-Park allow the user to park any call from an LVS 9000
phone and pick it back up from the same or a different LVS 9000 phone.
•
To Park a Call, Follow These Steps:
–
1. While the call is connected, press the “park” soft key on your LVS 9000 phone
–
2. Enter the parking lot number on which to park the call.
–
3. Result: Call is parked and you are disconnected from the call.
–
4. If configured, the parked caller is listening to music.
–
By default the Park * code is: 38
•
To Pickup a Parked Call (Sometimes Referred to as “Un-parking” a Call),
Please Follow These Steps:
–
1. Press the “unpark” soft key or dial the corresponding *code on your LVS 9000
phone.
–
2. Enter the parking lot number where the call is parked.
–
3. Result: You are connected with the parked call.
–
By default the Unpark * code is: 39