Braun 7546 - Manual (Page 9)

9
• Best environmental temperature range for charging is 15 °C to 35 °C.
• If the rechargeable battery is discharged, you may also operate the
trimmer via the mains cord. (If the trimmer does not run immediately,
charge it for approx. 1 minute.)
Using your beard trimmer
Speed selector
1 Normal setting for beard and contour trimming
2 High speed setting for strong beard and difficult areas (e.g. chin)
and hair cutting
A Beard trimming
• Place the distance comb on the beard trimmer while the on/off switch
is on position «0».
• To start trimming, press the on/off switch and push it up to the desired
beard length. You may choose between 6 settings: approx. 1, 3, 6, 9,
12, 16 mm.
• It is advisable to begin with the highest setting and then reduce the
setting until you reach the desired beard length.
• Hold the distance comb with the angled edge against your beard and
guide the trimmer against the direction of hair growth.
• As you become familiar with beard length settings, you may want to
adjust the memory switch to your preferred beard length setting by
sliding it up. With the preset memory switch, the motor will not start
before the on/off switch has reached the memory switch setting.
• To avoid clogging the distance comb with hair, clean it from time to time
with the brush. Please note that the distance comb can only be taken
off, when the trimmer is turned off.
B Hair cutting
• The hair should be clean, well combed, tangle-free and dry.
• Proceed as described under (A), but using the larger distance comb
(settings approx. 10 /12 / 15 / 18 / 21 / 25 mm). If you are not used to
clipping hair, begin with a higher setting and then reduce the setting to
avoid cutting more hair than desired. If you want to cut your hair shorter
than 10 mm, we advise to first cut it with the larger distance comb down
to 10 mm and then use the smaller distance comb for the desired
length.
5601196_EP100_MN Seite 9 Dienstag, 18. Januar 2005 10:54 10