Life Fitness Lifepulse Digital Heart Rate Sensors - Manual

How To... REMOVE AND REPLACE THE DIGITAL HEART RATE PC BOARD
Tools Required: Phillips screwdriver, pliers
Step 1
Remove the four SCREWS securing the DISPLAY CONSOLE to the DISPLAY CONSOLE BRACKET.
Step 2
Unplug the 16-PIN CONNECTOR and the 3-PIN CONNECTOR from the back of the DISPLAY CONSOLE.
Step 3
Remove the 9-Volt BATTERY from the back of the DISPLAY CONSOLE.
Step 4
Remove the SCREWS securing the back of the DISPLAY CONSOLE to the OVERLAY FACEPLATE. Set the
OVERLAY face down on a non-abrasive, flat surface.
Step 5
Ground yourself to the machine by attaching one end of a DISPOSABLE ANTI-STATIC GROUNDING STRAP to
your wrist and the other to a suitable grounding point on the exercise bike (eg: the metal part of the pedal crank
shaft).
Step 6
Use the pliers to squeeze the tips of the five SPACERS, one at a time, to allow removal of the HEART RATE PC
BOARD. Before lifting the HEART RATE PC BOARD from position, be aware that an 8-PIN CONNECTOR is
also securing the back of the board in place.
Step 7
Replace any damaged SPACERS with those included in the kit.
Step 8
Reverse Steps 1 through 6 to replace all parts in their proper positions.
Display Console model
shown for reference only.
M051-00K46-A026