Part 3 initial steps for installing your dryer, Warning – LG D3744W User Manual

Page 13

Advertising
background image

1 3

Part 3

INITIAL STEPS FOR INSTALLING YOUR DRYER

In addition to the following warnings, please refer
to manual section on Exhaust Requirements and
Maintenance. Warning: The dryer must be vented
to the outdoors. Please follow the instructions (and
all others in this manual) very carefully. Failure to
follow these instructions can result in death or fire.

• Do not use plastic or thin foil duct.
• Use 4" (10.2 cm) diameter rigid or semi-rigid

metal duct (

NOTE! Venting materials are not

supplied with the dryer, and you should obtain the
venting materials necessary for proper installation)

• Position the dryer such that the exhaust duct run is

as short as possible.

Clean old ducts before installing this dryer
• The male end of each section of exhaust duct must

point away from the dryer.

• Use as few elbow joints as possible.
• Use duct tape on all duct joints.
• Insulate ductwork that runs through unheated

areas in order to reduce condensation and lint
build-up on pipe walls.

PLEASE BE AWARE THAT FAILURE TO

EXHAUST THE DRYER CORRECTLY WILL
VOID THE DRYER’S WARRANTY.

WARNING!

• Use a heavy metal vent.
• Do not use plastic or thin foil duct.
• Clean old ducts before installing this dryer.
• Failure to follow these instructions can

result in death or fire.

!

ALTERNATE EXHAUST DIRECTIONS

1.

Remove screw and exhaust duct.

(Use exhaust kit part #3911EZ9131X.)

2-1.

Detach and remove the knockout that

matches the desired venting direction

(Right side not available on Gas Dryers)

2-2.

Connect a short piece of duct to the

blower housing and attach the duct to

the base.

3-1.

Insert the male end of a 4" elbow into the

female end of a short duct. Tape the joint.

3-2.

Insert this assembly elbow first through the

hole in the dryer and push the female end

of the elbow onto the male end of the

blower output shaft. Tape the joint.

STEP 3

Connecting the Exhaust
and Venting System.

The exhaust must be vented to the outside.
Improper taping and incorrect installation will
cause dryer malfunction.

Note

Advertising
This manual is related to the following products: