Lexmark X75 - Manual (Page 25)

21
All-In-One is not communicating with the computer
Printing troubleshooting
All-In-One prints slowly
Note: If you scanned a photograph with your All-In-One, the
file size could be too large to print with a selected
scanning resolution higher than 300 dpi.
Disconnect and reconnect both ends of the USB cable (refer to
your setup documentation for details).
Unplug the All-In-One from the electrical wall outlet, and then
reconnect the power supply (refer to your setup documentation
for details). Plug the All-In-One back in and turn the power back
on.
Restart your computer. If problems still persist, see “Uninstalling
and reinstalling the software” on page 25.
Close all programs not in use. The memory resources may be too
low.
Make sure your Print Properties Quality/Speed setting is set on
Normal or Quick Print. See page 5 for help.
Try printing a smaller file. If the memory resources are too low,
you may not be able to print a very large file. Consider purchasing
more memory.