Lt-700 setup instructions (cont.) – Listen Technologies LT-700-150 User Manual
Page 12
8
LT-700 Setup Instructions (cont.)
6
7
Place Batteries in Unit
Place two (2) AA batteries in the compartment, making note of the battery
polarity shown in the battery compartment, and again verifying that the
BATTERY SELECT switch is in the correct position for the batteries you are using.
(ALK should be selected for all battery types other than NiMH).
NOTE: Listen uses 2300mAh (milli-Amp-hour) constant current NiMH (Nickel
Metal Hydride) batteries. These may be purchased from your Listen dealer
(ask for part number LA-362).
Connect the Microphone
The microphone jack is located on top of the unit. The LT-700 uses the microphone
cable as an antenna for transmitting.
Optional - Connect the Line Input Cable.
This cable allows you to connect a TV, CD player or other
equipment to the LT-700. To do this, you must order the
Listen LA-263 Line Input Cable (it is not included with your
unit). This cable allows you to connect both a microphone
and line input to the jack on top of the LT-700. See the
diagram below for connection information. You can use the
microphone and the line input at the same time. Please note
that the MUTE switch mutes only the microphone; the line
source will continue transmitting when the switch is in the
MUTE position.
If you prefer to make your own cable for connection of mic
and line inputs, connection shown in the following diagram:
8
Stereo-Red
Mono-White
Video-Yellow
mm
1
LA-263