Land Pride BH3512 User Manual
Page 18
16
Section 1: Assembly and Set-Up
BH3512 Backhoes 340-131M
7/14/08
Land Pride
Bucket Installation
Refer to Figure 1-10:
Assemble the bucket (#1) with the pins (#2) and roll pins
(#3) as shown.
Locking Bar Installation (Optional)
1.
After the backhoe is attached to the tractor in working
position proceed with the following steps to install the
lower drawbar link locks in Figure 1-9.
2.
Install pins (#3) through eyebolt (#2) with the
eyebolts being located on each side of backhoe
lower link sockets. Secure pins in place with lynch
pins(#4).
3.
Install lower link lock angles right (J) and left (K) as
indicated in the drawing. Place lockwashers (L) and
install nuts (M) on eyebolts and snug nuts in place.
4.
Adjust the 3/4” bolt against the tractor drawbar link.
Lock adjustment screw (N) with locknut (O).
5.
Tighten eyebolt (#2) with nut and jam nut.
Bucket Installation
Figure 1-10
19369
Seat Assembly
Refer to Figure 1-11:
Assemble the seat as shown with the 3/8” flange nuts.
Adjust seat positioning to your comfort by releasing latch
located beneath the front of the seat.
Tractor Lower Link
Locking Bar Installation
Figure 1-9
Seat Assembly
Figure 1-11
19368