LG 26LC2D - Manual (Page 16)

16
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides
of the screen may remain visible on the screen.
VCR Setup
When connecting with an antenna
VIDEO AUDIO
VIDEO AUDIO
( )
S-VIDEO
AV
IN 1
AV
OUT
COMPONENT
IN
DIGITAL
OPTICAL
AUDIO OUT
VIDEO AUDIO
VIDEO AUDIO
( )
S-VIDEO
AV
IN 1
AV
OUT
COMPONENT
IN
DIGITAL
OPTICAL
AUDIO OUT
S-VIDEO OUT
IN
(R) AUDIO (L) VIDEO
3 4
OUTPUT
SWITCH
ANT OUT
ANT IN
ANTENNA/
CABLE IN
REMOTE REMOTE
CONTROL IN CONTROL IN
RS-232C IN
(CONTR (CONTROL & SER OL & SERVICE) VICE)
RGB IN
(PC) (PC)
AUDIO IN AUDIO IN
(RGB/DVI) (RGB/DVI)
SERVICE SERVICE
HDMI IN
1(DVI)
2
When connecting with a RCA cable
VIDEO VIDEO AUDIO UDIO
VIDEO VIDEO AUDIO
MONO ( )
S-VIDEO
A V
IN 1
A
V
OUT
COMPONENT
IN
DIGIT DIGITAL AL
OPTICAL OPTICAL
AUDIO OUT UDIO OUT
VIDEO AUDIO
VIDEO AUDIO
( )
S-VIDEO
AV
IN 1
AV
OUT
COMPONENT
IN
DIGITAL
OPTICAL
AUDIO OUT
S-VIDEO OUT
IN
(R) AUDIO (L) VIDEO
3 4
OUTPUT
SWITCH
ANT OUT
ANT IN
ANTENNA/
CABLE IN
REMOTE
CONTROL IN
RS-232C IN
(CONTROL & SERVICE)
RGB IN
(PC)
AUDIO IN
(RGB/DVI)
SERVICE
HDMI IN
1(DVI)
2
VCR
1
2
3
Connect the AUDIO/VIDEO jacks between TV
and VCR. Match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red)
Insert a video tape into the VCR and press PLAY
on the VCR. (Refer to the VCR owner’s manual.)
Select AV1 input source using the INPUT button
on the remote control.
- If connected to AV IN2, select AV2 input source.
• If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the
set.
1
1
2
3
4
Connect the RF antenna out socket of the VCR to
the ANTENNA/CABLE IN socket on the set.
Connect the antenna cable to the RF antenna in
socket of the VCR.
Set VCR output switch to 3 or 4 and then tune TV
to the same channel number.
Insert a video tape into the VCR and press PLAY
on the VCR. (Refer to the VCR owner’s manual.)
VCR
1
2
Installation