Lowrance electronic X86 TX - Manual (Page 26)

22
Install batteries in power case battery adapter.
Portable Transducer Assembly
Recommended tools for installation include a slotted screw driver and
two adjustable wrenches.
Assemble the transducer and bracket as shown in the following figure.
Attach the transducer to the bracket with the supplied hardware.
Make sure there is one washer on each side of the transducer, inside
the bracket. Slide the other washer over the end of the bolt and thread
the nut onto it.
Screw the suction cup onto the bracket using the supplied screw and
flat washer. Tie the nylon cord through the hole in the top of the
bracket. When using this transducer, tie the other end of the nylon cord
to the boat. This will help prevent the loss of the transducer if it comes
off the boat.
"D" cell battery