Lightolier 28702 - Manual (Page 2)

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:28702
1299 Page 2 of 2
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720 ®
INSTRUCTIONS FOR OPERATING A L0W-VOLTAGE METALLICS TM FIXTURE
WARNING: RISK OF FIRE. FIXTURES 8702 & 28702,
WHEN USED WITH AN OPTISPOT SHADE, GENERATE
INTENSE LIGHT BEAM. COMBUSTIBLE MATERIALS
MUST BE SPACED AT LEAST 4 FT. AWAY WHEN
USING THE 8710 AND 2 FT. AWAY WHEN USING
THE 8730 (SEE FIG. 5). ALWAYS USE CARE WHEN
ILLUMINATING HEAT SENSITIVE OBJECTS.
NOTE: For dimming, use only dimmers approved for use with
low voltage lamps and electronic transformers.
AIMING ADJUSTMENTS
CAUTION: ALLOW TIME FOR FIXTURE TO COOL
BEFORE MAKING ANY ADJUSTMENTS!
Rotate fixture to the desired position using the HOLE located
in the back of the ARM as a handle. Fixture has horizontal and
vertical rotation stops (DO NOT FORCE FIXTURE PAST STOPS.
DOING SO WILL CAUSE AN ELECTRICAL HAZARD).
See Figs. 6 & 7.
HORIZONTAL
ROTATION
ARM
HOLE
FIXTURE 28702 WITH
OPTISPOT SHADE (sold separately)
VERTICAL
ROTATION
OPTISPOT SHADE
Fixture 28702 with Optispot shade
(sold separately)
Fig. 6
Fig. 5
Applies only when
using the 8710, 8730
OptiSpot Shades
Fig. 7
FOR T4 LAMPING INFORMATION, SEE LIGHTOLIER INSTRUCTION SHEET 8710.
FOR MR16 LAMPING INFORMATION, SEE LIGHTOLIER INSTRUCTION SHEET 8727M16.
Fixture 28702 with MR16 Dome shade
(sold separately)
CAUTION: NEVER ENERGIZE OR OPERATE FIXTURE
28702 WITHOUT AN OPTISPOT OR MR16 DOME SHADE
ATTACHED. LAMP MUST BE COVERED AT ALL TIMES.