Lincoln Electric POWER ARC 5000 - Manual (Page 11)

A-4 INSTALLATION
POWER ARC 5000
A-4
Assembly of Wheels and Handle to the
Tube Frame
Tools Required - Two 9/16 wrenches or sockets, 3/8 wrench
or socket and a rubber mallet or wooden
block.
Refer to Figure A-2 for illustration of proper assembly.
a.) Set the machine on blocks so that it is raised up off
the floor by approximately 6 inches.
b.) Install two of the vibration isolators (Item 1) to the
bottom of each foot (Item 2) using one each of the
supplied 3/8-16 X .875 hex head bolts and lock-
washers on each foot. (Detail A)
c.) Install the two feet to the alternator support channel
using three each of the supplied 3/8-16 X .875 hex
head bolts, lock-washers, and 3/8 - 16 hex nuts on
each foot. (Detail A)
d.) Install the two axle support brackets (Item 3) to the
engine support channel using two each of the
supplied 3/8-16 X .875 hex head bolts and lock-
washers, two each of the supplied 3/8-16 hex nuts,
two each of the large plain washers (spacers), and
two each of the vibration isolators (Item 1). The two
vibration isolators are installed in the inward holes
furthest from the tube frame. Refer to Figure A-2
Detail B. The two large washers must be installed
between the vibration isolators and the underside
of the channel. The remaining two large plain
washers (spacers)are not used.
e.) Install one of the push nuts (Item 4) on one end of
the axle (Item 5) by supporting the axle vertical and
tapping on the push nut with a rubber mallet or
wooden block.
f.) Install one wheel (Item 6) on to the axle and slide
the axle through the slots in the two axle support
brackets. The axle will rest on the two vibration iso-
lators when the machine is set on the ground pro-
viding a type of suspension for the axle.
g.) Install the other wheel and push nut on the other
end of the axle.
h.) Loosen but do not remove the four screws that
hold the handle clips (Item 7) to the fuel tank sup-
port channel on the alternator end. Install the han-
dle (Item 8) through the large holes in the channel
and tighten the screws that were previously loos-
ened. The height of the handle can be adjusted to
suit the user.
8
7
3
6
4
5
1
1
2
Alternator Support Channel
3/8-16 Hex Nut (3)
Lockwasher (3)
Lockwasher
3/8-16 x .875 Hex Bolt (3)
3/8-16 x .875 Hex Bolt
Rubber Isolator
Item 1
Foot
Item 2
3/8-16 x .875 Hex Bolt (2)
Lockwasher
Hex Nut
Wheel
Item 6
Push Nut
Item 4
Axle Support Bracket
Item 3
Axle
Item 5
Engine Support Channel
Rubber Isolator
Item 1
Large Plain Washer
(Spacer)
Tubular Frame
Figure A-2
Detail B
Detail A