Lowrance electronic 350c - Manual (Page 50)

43
Press each of the targets in turn. After the third, the screen should be
calibrated. The calibration screen will disappear, returning you to the
Screen Setup Menu. You may want to use a stylus for more accurate
calibration (or even the plunger of a ballpoint pen) – if you do, take ex-
tra care not to scratch the touch screen.
Standby Mode vs. Power Off Mode
The power button turns the unit off and on in two different ways. When
the unit is on, holding the power button down for about two seconds
will put the unit in "standby mode." Standby Mode is your unit's de-
fault setting; it does not turn the unit completely off.
Standby Mode allows it to "sleep" and draw very little battery power.
Because the unit is not completely shut off, the next time you turn it on
it will start up faster than if the unit was fully shut down.
If the unit is left idle for 24 hours, it will automatically leave the
Standby "sleep" state and switch to a full shut down to save battery
power. However, the power button's Standby setting is unchanged; the
next time you power down, it will again return to Standby Mode.
If you wish, you can disable Standby Mode, so that the unit will com-
pletely shut down when you turn it off. To disable it, select
P
OWER
O
FF
.
In the Power Key box of the Interface Options Menu.
Options Menu – Page Three
Page 3 of the Options Menu contains the following options:
The iWAY Options Menu (Page 3).