Land Pride NT Series - Manual (Page 5)

5 06/21/07 Manual No. 701-149M
Assembly Instructions
Land Pride
■
is a fuse in the fuse holder. Turn the key switch to the on
position and test run the lift motor by pressing the up
button on the handlebar switch.
Verify that pressing the up button on the handle bar
switch causes clockwise rotation of the spool when
viewed from the open end. (See illustration below). If the
spool rotates counterclockwise, see the note on the
electric lift
wiring harness diagram on the previous page. The spool
should now rotate in the clockwise direction when
pressing the top button.
Run the spool in the direction necessary to end up with
one wrap of cable on the spool and the cable to the front
side of the spool.
With the blade resting on the ground, route the end of the
cable up through the quick link (#8) in the lift strap (#6),
and secure it with the Cable Clamp (#7).
NOTE: If the Blade is raised too high, the Push
Tube will contact the ATV frame and put an
excessive load on the Gear Motor and other parts.
Failure of the fuse may result. Stop the blade at a
point before this contact occurs.
ALSO: Be aware that if the switch is held in the
"DOWN" position after the Blade has contacted the
ground, the cable will start to wind up backwards on
the Spool.
A drop of oil on each end of the spool will keep the
spool lubricated. Do this periodically