Lennox Hearth D2 - Manual (Page 9)

Setting Up Your LaCie AIT Drive
page 9
LaCie d2 SCSI AIT Drive
3. Setting Up Your LaCie U&I AIT Drive
Connecting the AC Adapter
To operate the drive, you must use the AC adapter supplied with it.
Warning! Use only the AC adapter supplied with your LaCie drive. Using any other power cable may cause
damage to the device and void your warranty.
You may use your LaCie drive when in a foreign country, thanks to its auto-switching 100-240 Volt power
supply. To be able to use this feature, you may need to purchase an appropriate adapter. Consult LaCie
Technical Support for assistance in choosing the right adapter. LaCie accepts no responsibility for any
damage to the drive resulting from the use of an inappropriate adapter. Using an adapter other than one
authorized by LaCie will void your warranty.
Connecting the AC Adapter to the Drive
1) Insert the round, four-pin metallic plug of the AC cable into the power input located at the rear of the drive.
2) Connect the wall-side plug to a power socket.
Disconnecting the AC Adapter from the Drive
1) Turn the drive off and wait for it to spin down (+/- 10 sec.).
2) Hold the drive steady with one hand, then remove the plug from the connector.
Warning! Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter
may result in damage to your drive and will void your warranty.
3.1 Installing Your LaCie AIT Drive
There are five main steps to this installation process:
3.1.1 - Software Installation
3.1.2 - SCSI Card Verification
3.1.3 - Setting the SCSI ID Number
3.1.4 - Connecting the Drive to the Computer
3.1.5 - Drive Recognition
3.1.1 - Software Installation
In order to use your LaCie AIT drive, you will need to first install application software. Unlike a hard disk, CD-R/RW or
DVD-RAM/R/RW drive, the AIT drive will not be displayed on your Windows or Mac desktop, and will not be attributed a