Lenoxx Electronics CD203 - Manual (Page 5)

IB-CD203(AD)-WM-E-012503
You can use the AC power or batteries as a power source.
4
To a wall outlet
• Replace the batteries
when the POWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Before you replace
the batteries, be sure to
take out the CD from the
player and remember to
check the Battery Safety
Instructions on Page 3.
•
If the CD does not play
on batteries, this means
the batteries are almost
used up. But the radio
may continue to play on
these weak batteries
because it uses less
power than the CD
player.
TIP:
1. Connecting the AC power
Insert the AC plug (located at the battery
compartment) into 120V 60Hz standard household
outlet.
2. Using the player on batteries
Insert 8 size “C” batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the
AC power cord from the player.
BATTERY DOOR
(on the bottom of the set)
CHOOSING THE POWER SOURCES
Installing Batteries as illustration
NOTE: One blade of plug
and outlet is wider.
TIP
If the plug of the AC power
cord does not match your
outlet, do not force it.
Reverse it and try again.
The plugs are polarized
and only fit one way into
the wall outlet and back of
the set.