LG D3788W - Manual (Page 24)

2 4
Part 8 OPERATING YOUR DRYER
• Select a Manual Dry Cycle.
• Press MORE TIME or LESS TIME until the
desired drying time is displayed. Tap MORE
TIME or LESS TIME and the time will change by
1 minute intervals.
NOTE: The MORE TIME or LESS TIME
feature can be used with Manual Dry, Time Dry,
and Rack Dry Cycles.
• Press TEMP. CONTROL until the desired
temperature indicator glows.
• (OPTIONAL STEP) If desired, select OPTIONS.
For more details, see Options.
• Press START/PAUSE. Be sure the door is closed.
• If you do not press START/PAUSE within 10
minutes of selecting the cycle, the dryer
automatically shuts off.
• If you wish to end your drying cycle after pressing
START/PAUSE, press START/PAUSE again.
3. To use a Manual Dry Cycle
Properly loading your dryer can lower your utility
bill and prolong the life of your garments.
Loading suggestions
Load the dryer by the amount of space items take
up, not by their weight.
Do not overload the dryer. This causes uneven
drying and wrinkling.
Heavy Work Clothes
4 jeans
4 workpants
4 work shirts
2 sweatpants
2 sweatshirts
Cotton/Towels
10 bath towels
10 hand towels
14 wash cloths
Mixed Load
3 sheets (1 king, 2 twin)
4 pillowcases
3 shirts
3 blouses
9 T-shirts
9 shorts
10 handkerchiefs
Following are sample loads for Super Capacity
Dryers:
5. Loading
To stop your dryer at any time
Press START/PAUSE or open the door.
Pausing or Restarting
To pause the dryer at any time
Open the door or press START/PAUSE once.
To restart the dryer
Close the door. Press START/PAUSE.
NOTE: Drying will continue from where the cycle
was interrupted if you close the door and press
START within 10 minutes. If the cycle is
interrupted for more than 10 minutes, the dryer will
shut off. Select new cycle settings before restarting
the dryer.
4. Stopping Your Dryer
• Select an Sensor Dry Cycle.
• Select DRY LEVEL to adjust
how dry you want the load. As
the cycle runs, the control
senses the dryness of the load
and adjusts the time
automatically for the selected
dryness level.
• Select the desired Options.
• Press START/PAUSE
NOTE: DRY LEVEL selections can only be
made while using Sensor Dry Cycles. Selecting
MORE Dry or LESS Dry automatically adjusts the
sensed time needed.
2. To use a Sensor Dry Cycle