Linksys SD2005 - Manual (Page 12)

8 5-Port and 8-Port 10/100/1000 Ggabt Swtches
Chapter 2: Connect the Swtch
Connect a Category 5 Ethernet network cable to one of the numbered
ports on the Switch . Connect the other end to a computer or other
network device .
Connect the Ethernet Network Cable
NOTE: Use Category 5e Ethernet network cables for your
Gigabit connections .
Repeat step 2 to connect additional devices .
Connect the supplied power adapter to the power port on the
Switch’s side panel . Plug the other end of the adapter into an
electrical outlet .
Connect the Power
WARNING: Make sure you use the power adapter included
with the Switch . Using a different power adapter may damage
the Switch .
Power on the devices connected to the Switch . Each active port’s
corresponding LED will light up on the Switch .
Congratulations! The installation of the 10/100/1000 Gigabit Switch is complete.
2 .
3 .
4 .
5 .