Lincoln Electric Power Feed 10M - Manual (Page 3)

Power Feed 10M
[3]
A CLOSER LOOK
Printed circuit boards are trayed, potted
and filled with epoxy to provide a robust
environmental shield.
Key Controls
Synergic Control CV Voltage Display
Synergic Control CV programs feature an ideal voltage best suited for most
procedures. Use this voltage as a starting point for the weld procedure and
adjust if needed based on personal preference. When the voltage knob is rotated,
the display will show an upper or lower bar indicating that the voltage is above or
below the ideal voltage.
• Above ideal voltage (upper bar display)
• At ideal voltage (no bar displayed)
• Below ideal voltage (lower bar display)
Front:
1. Bright, high intensity large digital display of voltage and wire feed speed.
2. Dual Procedure Memory Panel - retain settings in memory to switch back and forth between two
different weld procedures. Use any of six memories to store your favorite settings.
3. MSP4 Panel (see page 2).
4. 2-Step/4-Step Trigger Switch — change from simple ON/OFF in 2-step position to trigger interlock in
4-step position.
5. ArcLink status Lighted Electronic Display.
6. Cold Inch/Gas Purge switch — feed wire through a gun, or purge gas line to set flow rate all with
welding output off for safety and gas savings.
7. Water Cooler Kit Connection (Optional).
8. 5-pin amphenol gun trigger connector.
Back:
1. Access Panel — remove to change DIP settings.
2. Shielding Gas Inlet — industry standard 5/8 - 18 CGA connection.
3. Spool Gun/Push-Pull Gun Connector — for connecting Python®, CobraMAX™ and Prince XL® guns.
4. Remote/Foot Amptrol Connector for TIG welding (Optional).
5. ArcLink Control Cable Connector.
6. Water Cooler Connector (Optional).
www.lincolnelectric.com
Press to select procedure.
Dual Procedure/Memory Panel Option shown
for Power Feed 10M Single Bench Model
The Dual Procedure/Memory Panel is standard equipment on
Power Feed 10M Dual Bench Models and optional on Single
Bench Models. This panel performs three functions: weld
procedure selection, feed head selection and memory
saving/recall. There are two procedure memories (A and B)
and six user memories (1- 6) for each feed head to store your
favorite settings.
QUALITY AND RELIABILITY
• Rugged steel case, sturdy controls and quality meter displays.
• Ambient temperature range for operation (-10° C to +40° C) and storage
(-40° C to +40° C).
• Designed to resist electrical noise.
• Conforms to
c
CSA
UL
/ CE Standards:
C22.2 No. 60, UL551, EN 60974-5, EN 50199.
• Meets IP21S rating.
• PC Boards are potted, trayed and filled with epoxy for ultimate protection in
harsh environments.
• Three-year Lincoln warranty on parts and labor.
• Manufactured under a quality system certified to ISO 9001 requirements and
ISO 14001 environmental standards.