Pioneer DEH-3300UB - Manual (Page 10)

2 Tighten two screws on each side.
1
2
3
1 Tapping screw (5 mm × 8 mm)
2 Mounting bracket
3 Dashboard or console
Removing the unit
1 Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Press the detach button and push the front
panel upward and pull it toward you.
For details, refer to Removing the front panel to
protect your unit from theft and Re-attaching
the front panel on page 5.
En
18
Section
03 Installation
Troubleshooting
Symptom Cause Action
The display
automatically
returns to the
ordinary dis-
play. You did not per-
form any opera-
tion within about
30 seconds. Perform operation
again.
The repeat play
range changes
unexpectedly. Depending on
the repeat play
range, the se-
lected range may
change when se-
lecting another
folder or track, or
when fast for-
warding/rever-
sing. Select the repeat
play range again.
A subfolder is
not played
back. Subfolders can-
not be played
when
FOLDER
(folder repeat) is
selected.
Select another re-
peat play range.
NO XXXX ap-
pears when a
display is chan-
ged (
NO TITLE,
for example).
There is no text
information em-
bedded. Switch the display
or play another
track/file.
The display is
illuminated
when the unit
is turned off. Demo mode is
on. ! Press to can-
cel demo mode.
! Turn off the
demo display set-
ting.
The unit is mal-
functioning.
There is inter-
ference. You are using a
device, such as a
cellular phone,
that transmits
electric waves
near the unit. Move electrical de-
vices that may be
causing the inter-
ference away from
the unit.
Error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to note the
error message.
Built-in CD Player
Message Cause Action
ERROR-11, 12,
17, 30 The disc is dirty. Clean the disc.
The disc is
scratched. Replace the disc.
ERROR-10, 11,
12, 15, 17, 30,
A0 There is an elec-
trical or mechan-
ical error. Turn the ignition
switch OFF and
back ON, or switch
to a different
source, then back
to the CD player.
ERROR-15 The inserted disc
is blank Replace the disc.
ERROR-23 Unsupported CD
format Replace the disc.
FRMT READ Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
NO AUDIO The inserted disc
does not contain
any playable
files. Replace the disc.
SKIPPED The inserted disc
contains DRM
protected WMA
files. Replace the disc.
PROTECT All the files on
the inserted disc
are embedded
with DRM. Replace the disc.
USB storage device/iPod
Message Cause Action
NO DEVICE When plug and
play is off, no
USB storage de-
vice or iPod is
connected. ! Turn the plug
and play on.
! Connect a com-
patible USB sto-
rage device/iPod.
FRMT READ Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
En
19
English
Appendix
Additional Information
<CRD4524-A/N>10