Replacing the system board access cover, Applying the option added label, 1 remove the backing from the label – Lexmark C 760 User Manual
Page 25
25
Install memory, firmware, or option cards
Replacing the system
board access cover
After you have finished installing cards on the printer system board, you must replace
the system board access cover.
1
Align the slots at the top of the access cover with the screws near the top of the
printer.
2
Slide the cover up under the top cover lip as far as it will go, and then tighten the
screws at the top of the cover.
3
Insert and tighten the four screws to the bottom of the cover.
If you installed a firmware card in your printer, see the following section for information
about applying the Option Added label.
Applying the Option
Added label
The Option Added label alerts service personnel that additional options have been
installed in your printer.
To apply the label:
1
Remove the backing from the label.
2
Place the label next to the printer model and serial number label.