Lantronix Hub - Manual (Page 31)

MSS User Guide 3: Getting Started
3-20
Once you have connected to the MSS, you will see the Lantronix Web Manager interface.
Use the left-hand menu to navigate to subpages where you can configure important
settings as well as view statistics and other device server information.
Figure 3-13. Web Manager Interface
EZWebCon Login and Configuration
EZWebCon enables users on TCP/IP networks to log into and configure the MSS. The
program offers a simple interface that prompts the user for the information necessary to
configure the device server. Instructions for installing, running, and using EZWebCon are
included on the CD-ROM.
Telnet
To log into the MSS, type Telnet followed by the MSS IP address. The MSS must have
an IP address assigned in order for this command to work.
Figure 3-14. A Telnet Connection
% telnet 192.168.0.10
Rlogin
Rlogin is similar to Telnet. It allows users to connect to a remote device. Rlogin is
enabled by default.
Figure 3-15: An Rlogin Connection
% rlogin 192.168.0.10
Serial Port Logins
Attach a terminal to the serial port and press the Return key. The Local> prompt should
be displayed. Proceed to
4:Configuration to configure the unit using the command line
interface.
If there is a problem during the boot process, pressing any key will display the Boot
prompt. This prompt enables you to enter a special set of commands, called Boot
Configuration Program (BCP) commands, which are discussed in
6:Troubleshooting .