LivinBox Storage Products Co. 24 - Manual (Page 15)

15
Car
e and Cleaning
Two Drawers
(on some models)
1. Remove the drawer farthest
from the door.
2. Remove the other drawer.
On models with a bottom door
shelf that blocks the other drawer,
slide the other drawer toward the
middle and remove it.
3. Remove the glass cover. Reach
in, push the front of the glass
cover up and, at the same time,
pull it forward as far as it will
come. Tilt it and take it out.
4. Remove the drawer frame.
(Always remove the glass
cover before you take out the
drawer frame.)
Lift the frame off the supports
at each side and back, pull it
forward, tilt it and take it out.
To replace:
1. Lower the frame until it rests
on the supports at each side
and back.
2. Replace the drawers.
If you removed the drawer slide,
replace it with the sloped end at
the front.
a. Slide one side of the drawer
onto the drawer slide.
b. Move the slide and drawer all
the way to the hinge side until
the other side of the drawer rests
on the frame.
c. Slide the other drawer into place.
3. Replace the glass cover, pushing its rear edge firmly into the rear
frame channel and gently lowering the front into place.
Frame
Drawer Slide
(sloped end)
Full-Width Drawer with Plastic Cover (on some models) Half-Width Drawer with Plastic Cover (on some models)
To remove the drawer, lift the
front up slightly and pull the
drawer straight out.
To remove the cover, lift it off its
supports, pull it forward and up,
tilt it and take it out.
To remove the drawers,
lift the front up slightly
and pull the drawer
straight out.
Light Bulb Replacement
A light bulb and socket are
located at the top of the fresh
food compartment opposite the
temperature control panel.
Some models also have a bulb
and socket in the upper left corner
of the freezer compartment
behind a flexible light shield.
To replace either bulb, unplug the refrigerator from its electrical
outlet, remove light shield, unscrew the bulb when cool, and replace
it with a similar size bulb.
(continued next page)