Land Pride RTR1042 - Manual (Page 28)

26 RTR10 & RTR15 Series Rotary Tillers 311-431M 11/01/11
Section 4: Maintenance & Lubrication
Table of Contents
Storage
Clean, inspect, service, and make necessary repairs to
the Rotary Tiller when parking it for long periods and
when parking it at the end of a working season. This will
help ensure that the tiller is ready for field use the next
time you hook-up to it.
!
DANGER
Always disconnect main driveline from tractor PTO and
secure tiller in the up position with solid supports before
servicing underside of tiller. PTO can be engaged if tractor is
started resulting in damage to tiller, bodily injury, or death.
1. Clean off any dirt and grease that may have
accumulated on the Rotary Tiller. Scrape off
compacted dirt and then wash surfaces thoroughly
with a garden hose.
2. Check the tines for wear and replace if necessary.
See Tine Replacement earlier in this section.
3. Inspect the tiller for loose, damaged, or worn parts
and adjust or replace if needed.
4. Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Land Pride Aerosol
touch-up paint. They are also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the Aerosol part number.
A coating of oil may be applied to worn surfaces in
lieu of painting to minimize oxidation.
5. Replace all damaged or missing decals.
6. Lubricate as noted below.
7. Drain and refill gearbox and chaincase oil. Be sure to
replace all oil plugs.
•
Drain oil in gearbox by removing the bottom drain
plug or right hand cap.
•
Drain oil in chaincase by removing the bottom plug
and tipping tiller backwards.
8. Store tiller on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer tiller life.
9. Follow all parking instructions on page 18 when
disconnecting tractor from tiller.
Land Pride Aerosol Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE AEROSOL SPRAY CAN
821-002C PAINT LP BLACK AEROSOL SPRAY CAN
821-066C PAINT ORANGE AEROSOL SPRAY CAN
821-054C PAINT MEDIUM RED AEROSOL SPRAY CAN
821-058C PAINT GREEN AEROSOL SPRAY CAN
821-067C PAINT BLUE AEROSOL SPRAY CAN
Lubrication
Driveline U-Joint
Type of Lubrication: Multi-purpose Grease
Quantity = As required
Driveline Shaft
Disconnect driveline shaft from the tractor and slide apart.
Clean and coat the inner tube of the driveline shaft with a
light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
8
Hours
20
Hours
14191
14190
50
Hrs
Multi-purpose
spray lube Multi-purpose
grease lube Multi-purpose
oil lube Intervals in hours at which
lubrication is required
Lubrication
Legend